05905 / 9454110
Kontakt
25 kg Levelling Coating System RAL7032 - Epoxy Resin | HP-E30VB
NEW
25 kg Levelling Coating RAL 7032 for Floor | E30VB
The epoxy resin system HP-E30VB is a coloured (similar to RAL 7032 pebbly grey) 2-component epoxy gradient coating with a medium working time for high-quality floor coatings with self-leveling gradient properties.
Properties:
- Self-leveling coating mass
- Very good adhesion properties, high abrasion resistance (in system structure with the epoxy resin primer E35GS)
- Very high chemical and mechanical resistance
- High-quality surface, which is easy to clean
- Free of solvents
- Coloured (grey, anthracite, green)
- Packaging sizes: 5 kg or 25 kg in a bucket
Areas of Application:
- Applicable on cement bounded surfaces
- For filling and smoothing of damaged floor areas
- High quality surface finishing indoors and outdoors
- Renovation of damagede and rough floors in workshops, garages, feeding tables in livestock farming, slaughterhouses, floors within the livestock keeping etc.
- Not applicable on curved or flexible surfaces
Application:
- Consumption: approx. 2 - 5 kg/m², depending on the substrate condition
- E30VB is poured onto the surface to be coated and spread using a floor squeegee. The layer thickness is determined by the notch size. The surface is then deaerated several times using a spiked roller.
Application Notes
1. Substrate Preparation:
The E30VB coating can be applied to new and old substrates. These must be dust-free, rough, sound, clean and dry. Mechanically smoothed or sealed floors should be sanded or sandblasted before coating. Breakouts, damaged areas and imperfections in the substrate should be filled flush with the surface using suitable cement mortars or our epoxy filler HP-E30S (prime breakouts and defective areas beforehand with E35GS epoxy resin). Afterwards, our E35GS primer should be applied over the entire surface. The primer acts as an epoxy resin moisture barrier and at the same time as an adhesion promoter between the mineral substrate and the subsequent coating. For optimum penetration into the pores, approx. 10% XB thinner should be added to the E35GS primer system.2. Application of the coloured roller coating E30VB:
After mixing both components of E30VB thoroughly and intensively, pour the mass on the surface and spread it with a squeegee or a scratch spatula. Then vent the surface with the nobby roller (HP-L1021) for minimizing air bubbles risen in the pores of the underground. This venting process should be repeated multiple times with a time delay between each process. If coating should be applied slip-resistant, fire-dried quartz sand can be applied.3. Recommended tools for processing:
Spiked roller, notched squeegee, plastic bucket, drill, mixing paddle attachment for drill.
Technical Data | HP-E30VB
✔ Pot life: 30 min✔ Mixing ratio (by weight): 100 parts resin / 117 parts hardener
✔ Mixed viscosity: Highly viscous (self-levelling)
✔ Processing temperature (minimum): 15 °C
Hazard Statements
Resin:Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H302+H332 Harmful if swallowed or if inhaled.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.
