05905 / 9454110
Kontakt
Epoxy resin primer system | HP-E80FS
Epoxy resin primer system | HP-E80FS
The epoxy system HP-E80FS is an unfilled, low viscosity 2-component combination of resin and hardener with a processing time of 35 min. It offers high adhesion even on mineral substrates. Our primer system can be used for the following applications:
✔ primer
...for substrates such as thermosets, wood, concrete, masonry, etc....
...very good wetting properties
...forms tack-free surfaces
✔ anti-corrosion coating
...for metal and aluminum (bright)
...forms water barrier layer
Hint:
Primer system HP-E80FS can be overcoated with adhesive or laminating resins and lacquers.
Can the HP-E80FS be applied directly to metal?
Yes, the HP-E80FS also adheres directly to metal if the surface is pretreated accordingly. Pre-treatment: Sand the metal and clean with acetone. Please refer to the data sheet.
Can the HP-E80FS be used for lamination?
Theoretically yes. Fibers can also be impregnated with this system. But basically the HP-E80FS is a primer system and should be used as such.
What residual moisture may the substrate still have?
HP-E80FS can also be used on substrates that still have a residual moisture content of approx. 6%.
The mixed HP-E80FS is relatively viscous, can I still dilute it?
Yes, it can be thinned with up to 10% thinner HP-XB, so that it is easier to paint and it penetrates better into the pores.
Within what time should I apply the finishing coat?
Basically, you should apply as soon as it can be walked on. At approx. 15-20°C this is possible within approx. 12 hours. Within 24 hours (at approx. 20°C) at the latest, the follow-up layer should be applied. After that, an intermediate sanding is necessary.
Why does HP-E80FS smell slightly more than other epoxy systems?
The hardener contains components that cause a slight aminic inherent odor. It is comparable to an ammonia-like inherent odor.
Technical data | HP-E80FS
✔ processing time: 35 min
✔ colour: yellowish/brownish
✔ mixing ratio (weight): 100 parts resin / 60 parts hardener
✔ mixing viscosity: low viscosity
✔ processing temperature (optimum): 20-25°C
Resin component:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener component:
Danger
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H411 Toxic to aquatic life with long lasting effects.
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener component:
Danger
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H411 Toxic to aquatic life with long lasting effects.